31
General Discussion / vnstatd
« on: December 23, 2018, 06:27:46 pm »
I'm using
OPNsense 19.1.b_492-amd64
FreeBSD 11.2-RELEASE-p4-HBSD
OpenSSL 1.0.2q 20 Nov 2018
Checking the logs i found this
Dec 23 11:35:16 vnstatd[63852]: Traffic rate for "em1" higher than set maximum 1000 Mbit (1->138, r2033 t225), syncing.
Dec 23 11:35:16 vnstatd[63852]: Traffic rate for "em0" higher than set maximum 1000 Mbit (1->138, r259 t2136), syncing.
Dec 23 11:35:16 vnstatd[63852]: Monitoring: em0 (1000 Mbit) em1 (1000 Mbit)
Dec 23 11:35:15 vnstatd[63852]: vnStat daemon 1.15 started. (uid:284 gid:284)
How can I set the proper rate or where? Why is the rate set low at 1000 Mbit?
OPNsense 19.1.b_492-amd64
FreeBSD 11.2-RELEASE-p4-HBSD
OpenSSL 1.0.2q 20 Nov 2018
Checking the logs i found this
Dec 23 11:35:16 vnstatd[63852]: Traffic rate for "em1" higher than set maximum 1000 Mbit (1->138, r2033 t225), syncing.
Dec 23 11:35:16 vnstatd[63852]: Traffic rate for "em0" higher than set maximum 1000 Mbit (1->138, r259 t2136), syncing.
Dec 23 11:35:16 vnstatd[63852]: Monitoring: em0 (1000 Mbit) em1 (1000 Mbit)
Dec 23 11:35:15 vnstatd[63852]: vnStat daemon 1.15 started. (uid:284 gid:284)
How can I set the proper rate or where? Why is the rate set low at 1000 Mbit?