16
20.7 Legacy Series / Shaper not showing IPs/subnets in the status active flows
« on: November 10, 2020, 04:46:58 pm »
Hey Guys,
Does any of you is experiencing the same issue where the shaper status is not showing IP address/subnets details in the active flows?
Should it shows the details about the socket that is using that flow? In my case it's always 0.0.0.0/0 for all active flows as per the screenshot attached.
Thank you!
tofaz
Does any of you is experiencing the same issue where the shaper status is not showing IP address/subnets details in the active flows?
Should it shows the details about the socket that is using that flow? In my case it's always 0.0.0.0/0 for all active flows as per the screenshot attached.
Thank you!
tofaz