Messages

Just add network interfaces as PCI devices. Do keep in mind that these interfaces will NOT be evailable to other VMs.

Rgds

Hi,
OPNsense running smoothly on our environments, both with & without NIC passrtrough.
Regards 

Hi,
I would suggest to verify firewall configuration on the new system as well as routing table on the LAN devices.
Hope this helps
Rgds

After the update the device no longer boots.

Any information on the console?

Hi there,

Running on metal or vm? Any accesss to console ?

Rgds

Hi there,
Not clear what your traffic plan should look like.
Yor plan is to forward traffic from your LAN through tunnel1 and traffic from your GUEST network through tunnel 2, right?

Hi there, make sure that the image you are loading has serial console enabled.

Now you shouls create NAT rules to forward all/part of your traffic through those tunnel interfaces.

Hope this helps

Kommisch!

Was kommt an der general Logs?

G.

The status of the interface is monitored by sending a ping packet to the Ip address defined on the gateway, which IP address are you using on the offline interface. Can you try to ping this IP when it goes down?

Rgds

I would recommend to check firewall rules on the Ovpn interface.

Hope this helps

Check firewall rules on the WAN interface accordingly. I guess that by "NAT Rule"you mean port forward, right? 

Hi there,
Is the LAN of the PBX the same network as the lcientes network?
Rgds

Check as well that Query forwarding is enabled to correct servers.
Rgds

Hallo,

Das Probel könnte am der NAT regeln liegen.

Habt ihr ein manuel regeln für LAN Verkehr richtung UTM9 Netz über den VPN eingerichtet?

G.