1
18.7 Legacy Series / Outbound NAT, no port range possible?
« on: September 05, 2018, 05:17:54 pm »
Hello everybody,
i want static ports for specific subnet and in a specific port range.
I am pretty sure i configured that in an older pfsense or OPNsense setup but now i can only set single ports or all?
Any ideas how to configure outbound NAT with static ports for all ports from 5000-6000 without creating a configuration for every single port?
Thanks.
i want static ports for specific subnet and in a specific port range.
I am pretty sure i configured that in an older pfsense or OPNsense setup but now i can only set single ports or all?
Any ideas how to configure outbound NAT with static ports for all ports from 5000-6000 without creating a configuration for every single port?
Thanks.