16
Hardware and Performance / Re: APU2D4 very low throughput 1Gbit
« on: May 28, 2021, 01:56:04 am »
I'd take Teklager's advice regarding fine-tuning OPNsense and APU2x4 to 1Gbit throughput with a grain of salt, since it's never been updated. On pfSense, however the advice has been upgrade thrice.
The OPNsense advise is not dated, but from a screenshot you can deduce that it's from 2019. The pfSense advice is dated, with the original post from 2019-01-15 with there subsequent updates, 2020-07-19, 2020-10-28 and 2021-02-20
https://teklager.se/en/knowledge-base/apu2-1-gigabit-throughput-pfsense/
"Gigabit config for pfSense 2.5.0. No tweaks are required! Don't follow any of the information listed below for pfSense 2.4.5."
If I'm not misinformed both OPNsense 21.1 and pfSense 2.5.0 are based on FreeBSD 12.2. Tuning these two system should consequently be pretty similar.
miroco
The OPNsense advise is not dated, but from a screenshot you can deduce that it's from 2019. The pfSense advice is dated, with the original post from 2019-01-15 with there subsequent updates, 2020-07-19, 2020-10-28 and 2021-02-20
https://teklager.se/en/knowledge-base/apu2-1-gigabit-throughput-pfsense/
"Gigabit config for pfSense 2.5.0. No tweaks are required! Don't follow any of the information listed below for pfSense 2.4.5."
If I'm not misinformed both OPNsense 21.1 and pfSense 2.5.0 are based on FreeBSD 12.2. Tuning these two system should consequently be pretty similar.
miroco