1
18.1 Legacy Series / CARP - OPNSense slow!
« on: April 13, 2018, 08:18:47 pm »
I am configuring 2 other OPNSense Appliances, running 18.1.6, and I've followed the documentation on how to setup CARP, and have set it up as I have done on 2 other pair of systems.
This time however as soon as I enabled CARP the 2 systems became very slow. They have a dedicated interface and cable connected between them, they can ping eachother fine, but as soon as I change something on the main system its spinning for about 10 minutes before the change is reflected on the other appliance and before I can do anything else on the system, so its very painful.
I tried to look into the logs, but...it takes about 10min of waiting after I do something, and then the logs seem to have changed since v17x..., so not sure where to find all the infos. That said the CARP communication are shown in Green, its just very slow.
The system reacts normally again if I disable CARP.
Does anyone had a similar experience or any idea what can cause this ?
This time however as soon as I enabled CARP the 2 systems became very slow. They have a dedicated interface and cable connected between them, they can ping eachother fine, but as soon as I change something on the main system its spinning for about 10 minutes before the change is reflected on the other appliance and before I can do anything else on the system, so its very painful.
I tried to look into the logs, but...it takes about 10min of waiting after I do something, and then the logs seem to have changed since v17x..., so not sure where to find all the infos. That said the CARP communication are shown in Green, its just very slow.
The system reacts normally again if I disable CARP.
Does anyone had a similar experience or any idea what can cause this ?