1
17.1 Legacy Series / Getting IPTV to work with VLAN and IGMPProxy
« on: March 19, 2017, 02:23:47 pm »
Hello,
I am sorry if this is a basic question but I am not very experienced with networking.
After changing from pfSense to OPNsense in hope that the bug with IGMPProxy not working on VLANs have been fixed, I have had very limited success in getting my IPTV working
I have made a IPTV VLAN with ID 20 that is connected through 2 smart switches to my IPTV box. I am successfully getting an IP that indicates correct VLAN.
OPNsense -> Smart switch -> Smart switch -> IPTV
The IGMPproxy is configured as following:
WAN upstream 83.255.222.0/24, 83.255.216.0/24, 224.0.0.0/4
IPTV downstream 192.168.20.0/24
While running tcpdump -n -i bce0 -e | grep "vlan 20" I can see the igmp reports, and they do show up if I run igmpproxy -d -vvv /usr/local/etc/igmpproxy.conf.
So far so good, right? Well, the IPTV does not work and if I check the states dump it says:
all igmp 224.0.0.251 <- 192.168.20.100 NO_TRAFFIC:SINGLE
all igmp 224.0.0.2 <- 192.168.20.100 NO_TRAFFIC:SINGLE
I have made a rule on the VLAN interface that says:
IPv4 * * * * * * Allow any with the "allow options" on.
On the WAN side I've made rules that says :
IPv4 UDP * * 224.0.0.0/4 * * TiVO: Pass UDP traffic prior to IGMP #1
IPv4 IGMP * * 224.0.0.0/4 * * TiVO: Pass IGMP traffic
Both have "allow options" on.
Any suggestions on what to do next?
I am sorry if this is a basic question but I am not very experienced with networking.
After changing from pfSense to OPNsense in hope that the bug with IGMPProxy not working on VLANs have been fixed, I have had very limited success in getting my IPTV working
I have made a IPTV VLAN with ID 20 that is connected through 2 smart switches to my IPTV box. I am successfully getting an IP that indicates correct VLAN.
OPNsense -> Smart switch -> Smart switch -> IPTV
The IGMPproxy is configured as following:
WAN upstream 83.255.222.0/24, 83.255.216.0/24, 224.0.0.0/4
IPTV downstream 192.168.20.0/24
While running tcpdump -n -i bce0 -e | grep "vlan 20" I can see the igmp reports, and they do show up if I run igmpproxy -d -vvv /usr/local/etc/igmpproxy.conf.
So far so good, right? Well, the IPTV does not work and if I check the states dump it says:
all igmp 224.0.0.251 <- 192.168.20.100 NO_TRAFFIC:SINGLE
all igmp 224.0.0.2 <- 192.168.20.100 NO_TRAFFIC:SINGLE
I have made a rule on the VLAN interface that says:
IPv4 * * * * * * Allow any with the "allow options" on.
On the WAN side I've made rules that says :
IPv4 UDP * * 224.0.0.0/4 * * TiVO: Pass UDP traffic prior to IGMP #1
IPv4 IGMP * * 224.0.0.0/4 * * TiVO: Pass IGMP traffic
Both have "allow options" on.
Any suggestions on what to do next?