91
19.1 Legacy Series / Re: Strange problem about stuck at booting
« on: April 07, 2019, 04:18:48 pm »
May be Franco mean that console:
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Do setting vmxnet3.netmap_native require reboot to take effect?
Hi Antaris,
Yes, you'll need a reboot. Make sure it's in effect. Use this command:Code: [Select]sysctl vmxnet3.netmap_native
Good news. I also have SBC, but still not supported by BSD.Looks like a great device with crypto support. Not sure if FreeBSD already have a supported device that has the same hardware. If they do, maybe can port it's uboot into Tritium.
It's a Libre Computer Tritium H5 2GB:
https://libre.computer/2019/02/07/linux-4-19-lts-images-for-tritium/
It only have support on Ubuntu, Debian and Armbian for now.
Ecept that it says 10GBase-T on the cover page and 8xSATA 3 but there are only boards with Quad GBit and 4xSATA3What abou AMD EPYC 3000: https://www.supermicro.com/Aplus/motherboard/Embedded/EPYC3000/
Are there drivers for that?
This boards will be very good with additional 2 to 4 SFP+ interfaces.
What abou AMD EPYC 3000: https://www.supermicro.com/Aplus/motherboard/Embedded/EPYC3000/
Are there drivers for that?
Of course everyone here on OPNsense that need a new router should visit the appliance shop and think about buying one of their products.. Just thinking about that, I'm curious(I will check later) if their product use ECC..
Greetings, mark
i am happily running my (home install) opnsense off of this board: https://www.gigabyte.com/Motherboard/GA-N3160TN-rev-10#ov
yes, its with realtek nics.
however i can use vlanning and get pretty much my full gigabit speed over the network, so i'm very happy with it.