31
22.1 Legacy Series / Re: DHCP send option not sent
« on: February 01, 2022, 01:01:34 pm »
May I suggest adding a sticky to 22.1 forum about this. Could save clicks and time.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Go to Interfaces: Assignments and select the VLAN parent and create a new interface with it. Go to the interface configuration and enable it. After that you can set media settings there and MAC address to spoof. Save. Last remove MAC from VLAN(s) and save + apply. It might need a reboot to reorder the MAC addresses when they were set upside down previously.
Cheers,
Franco
Thanks a lot @Franco for the time you spent for us
@nemric - Seems the version from 21.7 is working OK, at least on my test device so I'm attaching it here. No guarentees, but try it. At least you have a local device and can revert. @nivek1612 is concerned he might lose everyhing if he tries, so would you try it and let us know? Remember to set the permissions to 0555 after copying the attached to /sbin .
root@crawford:~ # ping 1.1.1.1
PING 1.1.1.1 (1.1.1.1): 56 data bytes
ping: sendto: No route to host
ping: sendto: No route to host
ping: sendto: No route to host
ping: sendto: No route to host
I am having Internet access issues post 22.1 upgrade. I did a tcpdump on the WAN interface when connecting to my ISP. A DHCP address is being offered and accepted but I get no traffic. Can't ping, nothing is getting out. Strange..
If you are getting a WAN v4 address, then it's not the client causing you issues. Try some deeper diagnostics from the WAN interface, ping 8.8.8.8 for example, if that works then try a ping to www.google.com, that will prove if the dns ( unbound ) is working. My test system which is running 22.1 is working fine, and it's a simple dual stack setup.
igb0_vlan10: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> metric 0 mtu 1500
description: WAN
options=4000400<LRO,NOMAP>
ether d4:a9:28:14:e8:98
inet6 fe80::d6a9:28ff:fe14:e898%igb0_vlan10 prefixlen 64 scopeid 0x6
inet 108.20.117.101 netmask 0xffffff00 broadcast 108.20.117.255
groups: vlan
vlan: 10 vlanproto: 802.1q vlanpcp: 0 parent interface: igb0
media: Ethernet autoselect (1000baseT <full-duplex>)
status: active
nd6 options=21<PERFORMNUD,AUTO_LINKLOCAL>
Guest (igb0_vlan200) -> v4: 192.168.200.30/27
LAN (igb0_vlan100) -> v4: 192.168.1.254/24
PIAWG (wg0) -> v4: 10.7.154.210/8
WAN (igb0_vlan10) -> v4/DHCP4: 108.20.117.101/24
PING 108.20.117.1 (108.20.117.1): 56 data bytes
ping: sendto: Host is down
ping: sendto: Host is down
ping: sendto: Host is down
ping: sendto: Host is down
ping: sendto: Host is down
ping: sendto: Host is down
Thanks, this is highly appreciated. Happy to hear the new installer ZFS mode is working as quite some time went into making this happen.
Cheers,
Franco