31
16.7 Legacy Series / Cannot complete boot from USB key
« on: November 15, 2016, 12:24:27 pm »
Hi,
I'm trying to install OPNsense from a USB key on an Atom-based computer (x64).
The initial bootloader works as expected, kernel boot messages are printed on the HDMI console, but the kernel (I guess) finally deadlocks without a clear reason after:
"ppc0: cannot reserve I/O port range".
I've edited the bootloader configuration file to disable the PPC, but it does not really go any further.
Booting in single user, verbose mode, the last traces are:
...
atkbd0: [GIANT-LOCKED]
psm0: unable to allocate IRQ
pcib0: allocate type 4 (0x3f0-0x3f5) for rid 0 of fdc0
pcib0: allocate type 4 (0x3f7-0x3f7) for rid 1 of fdc0
fdc0 failed to probe at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
ppc0: not probed (disabled)
pcib0: allocated type 4 (0x2f8-0x2ff) for rid 0 or uart1
There is no other message, and I do not know how to investigate from this point.
The same USB key boots fine within VmWare Fusion 8.5.1
How can I debug this issue?
Thanks.
I'm trying to install OPNsense from a USB key on an Atom-based computer (x64).
The initial bootloader works as expected, kernel boot messages are printed on the HDMI console, but the kernel (I guess) finally deadlocks without a clear reason after:
"ppc0: cannot reserve I/O port range".
I've edited the bootloader configuration file to disable the PPC, but it does not really go any further.
Booting in single user, verbose mode, the last traces are:
...
atkbd0: [GIANT-LOCKED]
psm0: unable to allocate IRQ
pcib0: allocate type 4 (0x3f0-0x3f5) for rid 0 of fdc0
pcib0: allocate type 4 (0x3f7-0x3f7) for rid 1 of fdc0
fdc0 failed to probe at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
ppc0: not probed (disabled)
pcib0: allocated type 4 (0x2f8-0x2ff) for rid 0 or uart1
There is no other message, and I do not know how to investigate from this point.
The same USB key boots fine within VmWare Fusion 8.5.1
How can I debug this issue?
Thanks.