Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - shornesr

#1
I was wondering... I have inherited a couple installs that were from back in the 17 or 18 version. I know I cannot do a direct upgrade but if I do a clean install of version 25 and import a backup config from the older versions should I expect any major issues? There has been no settings changed outside of the interface itself so it is just a basic and standard installation with a couple IPSec VPNs configured.
#2
I think I was looking in the wrong place... In the "Interface" drop-down list I found the Virtual IP... I will try that...
#3
That's what I thought but here are images of the settings and what shows...
#4
Thanks... that was it...
#5
I was wanting to try using a virtual IP to set up a site to site IPSec tunnel. I can get it to work just fine using the WAN address but I see no options for selecting the Virtual IP address...
I can also port forward using the Virtual IP and hit my web server that way.
I just do not see a way to set up an IPSec VPN using one of the Virtual IPs...
#6
17.1 Legacy Series / [SOLVED] Port Forwarding Issues
March 29, 2017, 03:48:45 AM
This is my rule in the port forwarding but when I run a port checker from the outside it tells me there are no open ports...
#7
16.1 Legacy Series / ipsec vpn and domain access
April 13, 2016, 06:39:48 PM
I have a remote network connected via an IPsec vpn. I can ping back and forth but how do I configure so that I can get to computers via the domain names? Also I may want to authenticate users to an Active Directory Domain on the other side of the VPN...