Messages

1

General Discussion / Update system via SSH

« on: June 21, 2024, 09:14:44 am »

Hi guys
Hope you doing well...

I have a remote location were is installed Opnsense.
I would like to update the system via SSH but most of the time the procedure is like freeze.

Picture attached

Is me that I am doing something wrong?
Thanks

2

Italian - Italiano / Usare WAN2 quando....

« on: March 08, 2022, 10:07:32 am »

Ciao a tutti
Ho bisogno di una mano nel configurare OPNSense.
Di seguito le info base:

Router IP: 192.168.3.1
Lan IP: 192.168.3.0/24
WAN1 : 110.45.89.90
WAN2: 192.168.4.3

Ho bisogno che se un qualsiasi PC che risiede sulla LAN 192.168.3.0/24 nel caso deve raggiungere un client con IP 192.168.4.0/24, il router utilizzi WAN2 e non WAN1

Qualcuno mi puo' dare una mano?

3

Italian - Italiano / Connessione internet si interrompe dopo circa 24h....

« on: February 24, 2021, 12:09:56 pm »

Ciao ragazzi....
Spero che stiate tutti bene.....

Ho un problem col mio collegamento a casa, vi do i dettagli di seguito:

Modem Teltonika TRB140 4G settato in bridge mode.
OPNSense box ( con ultima versione installata)

Premetto che prima utilizzavo PFSense e non ho mai avuto problemi.

Dopo essere passato a OPNSense, ho riscontrato la perdita di connessione dopo circa 24h.....
Il modem risulta connesso ma e' come se qualcosa succede e OPNSense perde l'accesso

Qualcuno con un esperienza simile che puo. consigliarmi il da fare?

Grazie

4

20.1 Legacy Series / Re: ZeroTier Networking between LANS

« on: February 11, 2021, 12:24:37 pm »

Hey guys

I think I have the same issue...but I am not a PRO!

Will be possible to have some extra help on how to do it please?
I think I have the same setup:
2 location with an OPNSense box on each side. Both have Zerotier installed and setup.

Need that the local network on site 1 can be reach form site 2 and vice versa.....
Like a SITE to SITE VPN

Thanks

5

Virtual private networks / Site to Site connection by using ZeroTier

« on: January 12, 2021, 01:04:11 am »

Hey guys
Hope everyone doing well.....

I can't fine much documentation online so I decide to ask the expert....

I have two office site connected on the internet via OPNSense firewall.
They both using a 4G modem, so no static internet IP.

Site1 -> 192.168.3.0/24   /  Firewall IP: 192.168.3.1

Site2 -> 192.168.2.0/24  /  Firewall IP: 192.168.2.1

Both sites have a printer and a NAS that we need share across location.

I successful install the ZeroTier plugin and join the ZeroTier network ID.
I set the two firewall with a static IP4 address inside the firewall interface setting....the same that is set on the ZeroTier web interface.

After that I don't know what to do because I can't ping any of address from one site to the other.

Do I missing something?

Thanks a lot