Messages

1

High availability / access backup instance via VPN

« on: September 05, 2022, 02:40:47 pm »

Hi all,

I am using HA setups at three different locations which are connected via wireguard VPN tunnels using dynamic routing with OSPF.
For easier administration I would like to access the backup instances via the tunnels. Any ideas how this can be achieved?

I thought of maybe solving this with VRF, but the frr service is being disabled as soon as the instance is switched into backup mode.

Cheers,
Albert

2

21.1 Legacy Series / Re: FRR Plugin Missing logs

« on: December 10, 2021, 08:04:04 am »

I ran into the same problem and wasn't aware where do disable circular logging.

Here is a hint for others:
it is a system option, so go to "System" -> "Settings" -> "Logging" -> first option

and then you need to restart FRR to have logging output

3

21.7 Legacy Series / Re: Wireguard multiWAN with HA site to site - Wireguard needs to follow CARP

« on: December 08, 2021, 02:58:32 pm »

here is the issue on github https://github.com/opnsense/plugins/issues/2524

4

21.7 Legacy Series / Re: Wireguard multiWAN with HA site to site - Wireguard needs to follow CARP

« on: October 01, 2021, 08:24:53 am »

Hi, I also want to implement a multiWAN site-to-site setup with wireguard in HA configuration and your suggested solution sounds very interesting and simple to add to OPNsense.

Looking forward to any action on this topic!

5

General Discussion / Re: WireGuard doesn't start with activated peer without Public Key

« on: May 25, 2020, 02:08:59 pm »

I have opened an issue here https://github.com/opnsense/plugins/issues/1850

6

General Discussion / Re: WireGuard doesn't start with activated peer without Public Key

« on: April 29, 2020, 06:06:01 pm »

I see the same problem running wireguard on OPNsense 20.1.5

As Hektor mentioned there are no Log entries and thus this problem is very difficult to debug.

Running `wireguard-go wg0` on the command line eventually reveals the problem in the wg0.config!