Messages

1

20.1 Legacy Series / Re: wan gui access

« on: March 24, 2020, 01:14:53 pm »

as a reference, if someone else has this setup, a good workaround is to declare a 2nd ip adress on the interface of the computer trying to access the gui:
for instance:

Code: [Select]

ifconfig wlp2s0:0 192.168.1.10 netmask 255.255.255.0 upand then, the machine can access the gui

2

20.1 Legacy Series / Re: wan gui access

« on: March 23, 2020, 11:28:05 pm »

Mâââgic ! It does indeed work now. I'd love to understand why ! And, how can the lan network now access the WAN ?

Many thanks for your help !

3

20.1 Legacy Series / wan gui access

« on: March 23, 2020, 09:19:06 pm »

Hello
I am discovering opnsense 20.1, and I have installed it on a vm in my lan, with 2 interfaces, LAN 192.168.1.1, and WAN 192.168.2.xxx - fresh install from the iso.
I am trying to access the management gui via the wan port - In system/settings/administration, I've defined listend to all ports for webgui, etc...
Interfaces WAN : I've unblocked private networks (and bogon networks, just in case !)
I've added a firewall rule, wan,  source any, destination wan address, port https
No luck - when I connect to the WAN IP, no gui comes up !
In the logs, I see my rule being triggered, in green, but not gui.

Out of despair, I've done the same config on a fresh pfsense, immediate success !
I've tried adding a nat rule, port forwarding to 192.168.1.1, no luck

Any ideas ? what could be wrong ??

J.

4

General Discussion / Re: WebGUI access from WAN??

« on: March 06, 2020, 08:20:04 pm »

sorry to revive an old thread, but it is really related. i've just installed OpnSense 20.1, and trying to access the gui from the wan interface
- in the system /  settings / administration / webgui, listen is to any interface
- I've created a fw rule to accept any source, destination wan address (or this firewall), https, not working
- I've created a nat rule, to accept any source, destination wan address (or this firewall), 8443, redirect 192.168.1.1/443, not working
- if I stop the firewall via pfctl -d, I can access the gui from the lan - but it is too radical

What could be wrong ?

J.