1
23.7 Legacy Series / Unable to Access Web GUI from OPT1: Access Denied
« on: January 18, 2024, 08:24:47 am »
Hello!
I have been having this problem literally since day one that I started using OPNSense. It didn't matter in the past, but I am moving to a new device and some of my requirements are changing. I have a rule set up to allow the opt1 network to access the opt1 address * * and I have two rules forwarding ports 80 and 443 to the Squid Proxy (transparent). I have the exact same rules on my LAN interface. On my LAN interface, I can access the firewall just fine using the LAN IP. On OPT1, I get an Access Denied message from Squid saying that Access Control is preventing me from accessing the GUI. I have checked every setting I can find, and I cannot find anything in the Web Proxy that would allow/prevent me from accessing the Web GUI. I checked the Settings and the Web GUI is listening on LAN and OPT1. I made sure that reply-to is disabled on the OPT1 firewall rule.
Does anyone have any other ideas as to why I can access the Web GUI just fine from the LAN interface, but not at all from the OPT1 interface?
I have been having this problem literally since day one that I started using OPNSense. It didn't matter in the past, but I am moving to a new device and some of my requirements are changing. I have a rule set up to allow the opt1 network to access the opt1 address * * and I have two rules forwarding ports 80 and 443 to the Squid Proxy (transparent). I have the exact same rules on my LAN interface. On my LAN interface, I can access the firewall just fine using the LAN IP. On OPT1, I get an Access Denied message from Squid saying that Access Control is preventing me from accessing the GUI. I have checked every setting I can find, and I cannot find anything in the Web Proxy that would allow/prevent me from accessing the Web GUI. I checked the Settings and the Web GUI is listening on LAN and OPT1. I made sure that reply-to is disabled on the OPT1 firewall rule.
Does anyone have any other ideas as to why I can access the Web GUI just fine from the LAN interface, but not at all from the OPT1 interface?