Show Posts
1
General Discussion / Re: Port nating
« on: March 18, 2019, 12:31:23 pm »
I would like to take up the topic again.
I put the NAT mode on hybrid and inserted the following NAT rule as shown in the attached picture.
It is not working.
I have created an interface named "ModemAccess" on re0 where WAN access already is and assigned the static IP address 192.168.1.2/24.
Is it a firewall rule that can block here? I have already added a firewall rule that allows access from "LAN" to "ModemAccess net".
Greetings
Florian
I put the NAT mode on hybrid and inserted the following NAT rule as shown in the attached picture.
It is not working.
I have created an interface named "ModemAccess" on re0 where WAN access already is and assigned the static IP address 192.168.1.2/24.
Is it a firewall rule that can block here? I have already added a firewall rule that allows access from "LAN" to "ModemAccess net".
Greetings
Florian