Messages

"hope the devs can fix this"

- Sorry, was clumbpy of me saying so.

The system I'm setting up is using guest authentication over FreeRadius, hosted on a Raspberry Pi in the network. It's used for handling stay-in guests in a hotel. The voucher auth is used only be restaurant guest, i.e. lunch guests or people in need of a 2 hous pass or so.

That's the reason why I need a simple voucher system with an actual voucher. Like I said, OpnSense looked great at a glance, pretty GUI and everything, but in my case I won't be able to use it until there is a plugin or similar like the voucher option in pfS.

Didn't mean like that, not at all, I'm impressed with what I saw (except the fact that I couldn't get internet through), just saying for the client where I'm putting this up, I have to run pfSense since they have an easy way to let guests autenticate using vouchers. Nothing bad to say, just not the right router software in this particular case.

Thanks for your reply!

I started from the beginning by restoring to factory defaults, did a setup just like my previous one, and this time internet was working on first login, very strange I must say..

However, I discovered the "vouchers engine" in OpnSense isn't vouchers at all, but username and passwords (just like the radius autentication). The whole point with vouchers is that they are easy to use, maintain etc. When testing the vouchers in OpnSense I just realized it'll be too hard on the intented customers for this setup, that's why I 'll go with pfSense this time.

Hope the devs can fix this, a voucher should be a voucher with a 5-6 character code, not require a full username and password.

Hi!

Been working with pfSense for quite a while and decided to give OpnSense a try. Installation/first setup went smooth, have assigned NICs as:

em0 - WAN - DHCP 192.168.254.254/24
em1 - LAN - DHCP 192.168.225.1/24

1 Gateway "ONLINE" for WAN with address 192.168.254.254   .

For some reason I won't be connected to internet via LAN it won't just work. I can login to the WebGUI and have had a look around. First I checked the NAT/Outbound settings as well as the firewall. I added a rule on WAN to allow traffic from LAN IPv4 to "any". No difference, still no internet.

OpnSense however are connected to internet, updated to last version without any problem. I can ping etc.

No idea what I'm doing wrong, ended up with disabling NAT, I disabled the firewall (packet filtering OFF) but still no connection to internet.

I'm very close of just giving up, can't find any information online, my setup is according to the docs.

Any help appreciated, thanks!