Messages

1

17.7 Legacy Series / Re: How to use freeradius as radius server for the captive portal?

« on: November 27, 2017, 01:22:15 pm »

Hi both,
I had the similar problem with a all new installation from USB-Stick, upgrading to 17.7.8 and then starting Radius.
It did not. Had to delete manually and reinstall -  now it works. But I don't know why?
Markus

2

Documentation and Translation / Re: Translation

« on: November 13, 2017, 08:05:10 pm »

Hi Fabian,
would it be appropriate to post corrections for V17.7 for the german translation here or shall I send you a PM ?
Markus

3

General Discussion / OPNsense 17.7 on an Intel NUC BOXNUC6CAYH

« on: November 02, 2017, 12:57:32 pm »

Hi all,
the only way I can contribute to the project right now is to report about my first steps and stumblestones
to implement an OpnSense Captive Portal Firewall Solution on an Intel NUC.

1) I don't want to discuss why I used an intel Nuc - I do have my reasons 
2) The device is quite cheap - with 4GB of RAM w.o. HD for < 150€
3) The NUC comes with a 1GB NIC and a Wifi / Bluetooth Network-Card --> not found by OpnSense / freeBSD yet,
it has a 4 Core Intel Celeron j3455 inside which is quite bored from a normal captive portal via a VLAN and an
SD-Card slot included which is bootable from bios but gets stuck in the opnSense boot process
4) Installation via an USB Stick is easily running through the process when having a 2.5" HD (found one) inside
5) Installation via the NANO Image on an SD Card was not successfull yet due to general boot problems
6) After configuration of 3 VLANs attaching WAN, LAN and OPT1 to it, runs quite well:

6.1) Throughput with the captive portal on an old WIFI Router/Switch running LEDE reaches physical limit of
100MBit --> Enough for (me) Internet sharing of a 100MBit line
6.2) Dashboard attached
6.3) When having more experience I will report