1
17.7 Legacy Series / Re: I seriously cannot install opnsense on to USB
« on: December 04, 2017, 10:21:28 pm »
Unfortunately i don't. Will that help? maybe i can try and download ubuntu and see if it will work.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
17.7 Legacy Series / I seriously cannot install opnsense on to USB
« on: December 04, 2017, 08:00:51 pm »
I have googled, searched on this forum but all answered provided have not yet solved my issue. Am trying to write the VGA image(v. 17.7.5) on to a USB drive so as to install on my desktop pc with the below specs;
Model: Dell optiplex 755
BIOS : A22
RAM: 2GB
HDD:160GB
I have tried using all softwares i.e rufus,win32 disk imager but with no luck. Rufus says the "image is either not bootable or is not supported by rufus" while win32 disk imager will write to disk but when i plug onto my desktop it says "no boot file found".Have tried also on 2 other laptops(lenovo think pad 3450 and dell latitude e6230) with the results being the same.
Any help is highly appreciated.
Regards,
Druplex.
Model: Dell optiplex 755
BIOS : A22
RAM: 2GB
HDD:160GB
I have tried using all softwares i.e rufus,win32 disk imager but with no luck. Rufus says the "image is either not bootable or is not supported by rufus" while win32 disk imager will write to disk but when i plug onto my desktop it says "no boot file found".Have tried also on 2 other laptops(lenovo think pad 3450 and dell latitude e6230) with the results being the same.
Any help is highly appreciated.
Regards,
Druplex.
3
17.1 Legacy Series / Cannot connect to the internet
« on: May 30, 2017, 04:10:15 pm »
Hi all,
Am not new to open source as i have been using pfsense and i just decided to try out opnsense. Funny thing is that my opnsense box can be able to get out to the internet but the local lan cannot. I have enabled DHCP and made sure that client computers are receiving the correct addresses. I had a similar situation when i first installed PFsense but it was easy to rectify as i had to change the upstream gateway to none. I have also checked on the default firewall rules and they are all the same between PFsense and Opnsense.
So what would be happening?
Am not new to open source as i have been using pfsense and i just decided to try out opnsense. Funny thing is that my opnsense box can be able to get out to the internet but the local lan cannot. I have enabled DHCP and made sure that client computers are receiving the correct addresses. I had a similar situation when i first installed PFsense but it was easy to rectify as i had to change the upstream gateway to none. I have also checked on the default firewall rules and they are all the same between PFsense and Opnsense.
So what would be happening?
Pages: [1]