Show Posts
1
17.1 Legacy Series / Re: [SOLVED] 17.1 install on Hyper-V does not see the HD, 16.7 does
« on: March 24, 2017, 07:51:06 am »
One more issue with Hyper-V:
1. After install v17.1 needs to use menu case 3.
2. Enter command - set hw.ata.disk_enable="1" (/boot/loader.conf)
3. After that enter - boot
4. All will be allright, but ... next shutdown and you need to make these things one more time.
NB! Only shutdown and network adapters movements reset config changes to default.
If you once config this firewall and save state it works perfectly.
1. After install v17.1 needs to use menu case 3.
2. Enter command - set hw.ata.disk_enable="1" (/boot/loader.conf)
3. After that enter - boot
4. All will be allright, but ... next shutdown and you need to make these things one more time.
NB! Only shutdown and network adapters movements reset config changes to default.
If you once config this firewall and save state it works perfectly.