Show Posts
1
General Discussion / captive + radius doesn't seems to work.
« on: July 29, 2015, 04:52:40 pm »
hi all. I'm migrating from Monowall to opnsense 15.7. unfortunatelly the config is not portable. In mono I was already using a radius server and all was working perfectly. In opn for some reason It does not. The radius is on wan zone, receive requests and provide answer to the opn: " Access-Accept" but the auth login page provide a "error sending request: Non valid RADIUS RESPONSES received".
Is there something I should do/enable? I also have a rule: tcp/udp accept all in wan adress, which is the side the radius is located. This should allow everithing from that zone.
in logs/firewall the relative track is:
@61 pass in log quick on bge0 reply-to (bge0 192.168.2.98) inet proto udp from any to 192.168.2.38 keep state label "USER_RULE: tutto da zenone"
which seems it means the answer did pass.
furthermore in mono I had a rule "any -> 192.168.2.50 radius server" which did enable browsing that server also before authentication. the same rule in opnsense redirects me to the login page.
any help is really wellcome.
Sebastiano
Is there something I should do/enable? I also have a rule: tcp/udp accept all in wan adress, which is the side the radius is located. This should allow everithing from that zone.
in logs/firewall the relative track is:
@61 pass in log quick on bge0 reply-to (bge0 192.168.2.98) inet proto udp from any to 192.168.2.38 keep state label "USER_RULE: tutto da zenone"
which seems it means the answer did pass.
furthermore in mono I had a rule "any -> 192.168.2.50 radius server" which did enable browsing that server also before authentication. the same rule in opnsense redirects me to the login page.
any help is really wellcome.
Sebastiano