Topics

Just notinced after 23.7 upgrade, all my firewall groups are not showing under 'Interfaces' section anymore. After tinkering with this for a bit, I noticed the groups will show IF only one member is selected.
When multiple members are selected, the interface disappears, but it still present in form under RULES section - this didn't happen in 23.1.11.

I've checked the '(no) GUI groups' option - it's not ticked, but doesn't matter anyway as it's no longer honouring this check mark.

It appears post 23.1.11 - 23.7 upgrade, all my port forward rules are no longer honoured.

NAT outbound rules seem fine & routing properly. DNS port forward rule doesn't seem to be using the gateway I selected and instead is using the default gateway.

Hi all -

Having issues with the Shaper, in particular when using VLANs.
Under Firewall - Shaper - Rules I have a rule for one of my VLANS whereby I have selected WAN as the primary interface & (VLANx) as the secondary interface. I use this rule to catch traffic on this VLAN to give it certain priority - works well.

IF however, I setup an additional rule underneath this VLAN rule (next sequence number), and select WAN as the primary interface with nothing in the secondary - the two rules conflict and the shaper seems to share the bandwidth between the two rules. This rule is used as a 'catch all' for all other traffic - other than the VLAN in the previous rule.

The result is that the total throughput flow is reduced by a small margin.

To get around this, I deleted the vlan from Interface2 & used source/destination IP subnets that correspond to the VLAN - with this setup the rules/flows/traffic is spot on....


Any thoughts?