Topics

Hi all,

Having an issue getting zerotier to work properly and I followed the documentation opnsense has. After I configured everything and I reboot the firewall, it seems to interfere with my WAN even tho it has its own gw with a very low priority. I don't get Internet at all unless I disable the zerotier interface.

Need some assistance in getting this working properly because I would like to remote in where ever I go to my home network.

Any suggestions I could check first?

Thanks

Hi all,

Having an issue getting zerotier to work properly and I followed the documentation opnsense has. After I configured everything and I reboot the firewall, it seems to interfere with my WAN even tho it has its own gw with a very low priority. I don't get Internet at all unless I disable the zerotier interface.

Need some assistance in getting this working properly because I would like to remote in where ever I go to my home network.

Any suggestions I could check first?

Thanks

Hey all,

I want to start by saying that before updating from 23.7.4 everything worked flawlessly, no issues with anything. Since updating to 23.7.9, i don't get internet access at all. If I log into the shell i get no route to host which is weird. I even did a factory reset, updating from 23.7 to 23.7.9 and restored my config, same issue. Reset again to 23.7, updated to 23.7.9 and this time all I added was my config to my ISP (PPPoE config) and still doesn't work.

Is this a known issue?? I could reinstall 23.7 and reload my config but I worry that any updates going forward will just brick everything again.

EDIT: I figured out why it was causing this problem, I had zerotier installed and it some how was taking over acting as the WAN rather than my ISP configured port. Not sure how to stop it from acting this way.

Hey,

So i am not a networking expert but I am hoping to get some assistance with an issue i am dealing with. Currently I have a mini pc with multiple ports and one port I labelled as a LAN port with subnet 10.0.0.0/24, main LAN is 192.168.1.1

I can't seem to get internet going on this LAN and I think my rules are wrong, even a simple ping would work for a bit then fail entirely.

I currently have the LAB network, any port going to the WAN address as destination with any port for port and gateway.

Is that the wrong rule?

Hi All,

Was thinking about purchasing this little unit and was wondering if anyone has experience with the intel nic's inside?

I have seen tons of posts on reddit about the intel i225 being complete garbage but not sure if peoples experience is on windows. Makes me wonder if the experience is the same on freebsd or even linux? I have seen the i226 but it seems like a rehash of the i225.

If anyone has a recommendation for a regular gigabit unit with 6 ports I am all ears.

Thanks in advance.