Show Posts
1
22.7 Legacy Series / no connection with 22.7, fine with 22.1
« on: September 12, 2022, 12:03:12 pm »
Hi,
I run a couple of opnsense installs in a datacentre where the provider requires that the WAN interface is set to 100baseTX Full-Duplex. Autonegotiation is not supported. This has been working fine since I switched from pfSense a few years back. The interfaces in question are I350-AM4 (igb) built into Supermicro M11SDV-4CT-LN4F.
With 22.7 I have no connection and ifconfig reports "status: no carrier" on these interfaces.
In my troubleshooting if I select autonegotiation (albeit unsupported by the provider) it defaults to 100baseTX half-duplex which sort of works but has many errors and collisions.
Downgrading to 22.1 restores normal functionalilty.
I run a couple of opnsense installs in a datacentre where the provider requires that the WAN interface is set to 100baseTX Full-Duplex. Autonegotiation is not supported. This has been working fine since I switched from pfSense a few years back. The interfaces in question are I350-AM4 (igb) built into Supermicro M11SDV-4CT-LN4F.
With 22.7 I have no connection and ifconfig reports "status: no carrier" on these interfaces.
In my troubleshooting if I select autonegotiation (albeit unsupported by the provider) it defaults to 100baseTX half-duplex which sort of works but has many errors and collisions.
Downgrading to 22.1 restores normal functionalilty.