Topics

This morning I upgraded from 24.1.10 to 24.7.  I've been successfully using the AT&T bypass which uses WPA_Supplicant along with Netgraph as seen in the instructions here:  https://github.com/owenthewizard/opnatt

Unfortunately, it hangs upon booting up.  See attached screenshot.  It no longer seems to pull the WAN IP anymore.  I can do a Control + C to continue to boot but even within the GUI, it doesn't pull an IP anymore.

Any ideas on what I could try to fix it?  It's been working great for so long prior to this update. 

Many times on my new install of OPNsense 22.7.2 upon saving/applying changes, I receive a "Your connection was interrupted" message in my browser. 

I'm using Brave (which is based off Chromium)

Your connection was interrupted
A network change was detected.
ERR_NETWORK_CHANGED

Is this a known issue?  I have to manually go back into the site for it to load again.