Topics

I've just upgraded from a PPPoE based 900 / 110 full fibre contract to a DHCP based 2000 / 2000 with YouFibre.

I get 2000 / 2000 with the supplied router using Windows 11 and Ookla speedtest.

I get 1400 / 1400 with my N100 i226 based router both from bare metal OPNsense cli and Windows 11 (direct connection to the router).

I get similar 1400 / 1400 iperf3 numbers to and from Win11 to OPNsense (and over 2000 both ways to Unraid on the network)

I was hoping that my router would run at full 2000 / 2000 speed. Am I being unrealistic?


System:

CWWK / Topton CW-ADLN-5L Ver: 1.0 Fengshang Edition

Bios Build Date and Time - 04/26/2023 14:02:13
Bios settings:
• ASPM disabled on all ports
• PCIe speed set to Auto on all ports

N100

16GB DDR5 Ram
1TB Samsung 980 NVMe

5 port Intel I226-V
  EEPROM V2.17-0 eTrack 0x80000303

####
No line shaping or IDS/IPS.

Interfaces:
• Disable hardware checksum offload - checked
• Disable hardware TCP segmentation offload - checked
• Disable hardware large receive offload - checked
• VLAN Hardware Filtering - Disable VLAN Hardware Filtering

Tunables:
dev.igc.*.fc = 0
net.inet.rss.enabled = 1
net.inet.rss.bits = 2

net.isr.dispatch = deferred
net.isr.bindthreads = 1
net.isr.maxthreads = -1

/boot/loader.conf.local
hw.pci.enable_aspm = 0

After every reboot I need to restart radvd in order to get an IPv6 address on my windows machine.

Code Select Expand


2023-08-01T16:30:05 Notice opnsense 70262 /usr/local/etc/rc.newwanipv6: Failed to detect IP for WAN[wan]
2023-08-01T16:30:03 Notice dhcp6c 69003 dhcp6c_script: REQUEST on pppoe0 renewal
2023-08-01T16:30:03 Notice dhcp6c 62709 dhcp6c_script: REQUEST on pppoe0 executing
2023-08-01T16:30:02 Notice opnsense 19569 /usr/local/etc/rc.newwanipv6: Failed to detect IP for WAN[wan]
2023-08-01T16:30:02 Notice dhcp6c 46570 RTSOLD script - Sending SIGHUP to dhcp6c