"
I have an OpenVPN server set up in one location, and 2 remote sites that I am trying to set up a site-to-site with.
Server Settings:
Tunnel Network: 10.x.x.0/24
Local Network: 192.168.x.0/24
Remote Network: 192.168.y.0/24,192.168.z.0/24
Client Specific Overrides:
Client Y:
Tunnel Network:
Local Network:
Remote Network: 192.168.y.0/24
Client Z:
Tunnel Network:
Local Network:
Remote Network: 192.168.z.0/24
OpenVPN Connection Status:
Laptop Virtual Address: 10.x.x.2
Client Y Virtual Address: 10.x.x.3
Client Z Virtual Address: 10.x.x.4
However, when I look at the routing table, I see the following:
Destination: 192.168.y.0/24 Gateway: 10.x.x.2 (wrong, should be .3)
Destination: 192.168.z.0/24 Gateway: 10.x.x.2 (wrong, should be .4)
This is despite the fact that neither one of them use 10.x.x.2 as their ip address. If I FORCE one of the remote sites to use 10.x.x.2 (using "ifconfig-push 10.x.x.2 255.255.255.0"), it works for that one. But of course I cannot force both of my Sites to use the same tunnel address. I have also tried overriding the tunnel address but that doesn't work either.
This seems like it has to be a bug. Either the route builder is pulling the ip address from the wrong place, or it should be routing those subnets to the OpenVPN server at 10.x.x.1 instead to hand off routing.
Server Settings:
Tunnel Network: 10.x.x.0/24
Local Network: 192.168.x.0/24
Remote Network: 192.168.y.0/24,192.168.z.0/24
Client Specific Overrides:
Client Y:
Tunnel Network:
Local Network:
Remote Network: 192.168.y.0/24
Client Z:
Tunnel Network:
Local Network:
Remote Network: 192.168.z.0/24
OpenVPN Connection Status:
Laptop Virtual Address: 10.x.x.2
Client Y Virtual Address: 10.x.x.3
Client Z Virtual Address: 10.x.x.4
However, when I look at the routing table, I see the following:
Destination: 192.168.y.0/24 Gateway: 10.x.x.2 (wrong, should be .3)
Destination: 192.168.z.0/24 Gateway: 10.x.x.2 (wrong, should be .4)
This is despite the fact that neither one of them use 10.x.x.2 as their ip address. If I FORCE one of the remote sites to use 10.x.x.2 (using "ifconfig-push 10.x.x.2 255.255.255.0"), it works for that one. But of course I cannot force both of my Sites to use the same tunnel address. I have also tried overriding the tunnel address but that doesn't work either.
This seems like it has to be a bug. Either the route builder is pulling the ip address from the wrong place, or it should be routing those subnets to the OpenVPN server at 10.x.x.1 instead to hand off routing.
