Topics

Hi. since all the firewall changes things broke and I'm struggling to find a guide that makes it clear how to force everything through the tunnel using the current naming convention and GUI.

Followed this guide https://blog.ssb-tech.net/posts/airvpn-on-opnsense/ in the past and had zero issues but now I'm deep in the weeds.

Very basic setup of one IP range and one tunnel - which is up. DNS stuff seems well handled by this guide https://paulsorensen.io/dnscrypt-adguard-home-opnsense/

Thanks to both writers and thanks in advance

Hi, new here and to this level of networking equipment in general, it's been a pretty steep learning curve! Tried to search locally and on the wider internet for a solution but due to lack of correct vocabulary I'm not 100% which keywords I should be using.

The (current) aim is to have OPNsense run a VPN for the entire network while also allowing a ShieldTV (static IP) running its own VPN client through the firewall. Tried putting a pass rule in LAN to route the STV direct to WAN gateway instead of to VPN_WAN and made sure it was above the regular traffic rules, also enabled "Don't pull routes." According to the OPNsense dashboard graphs STV still goes through the main VPN tunnel and then onto the correct end point.

It works ok but it's not how I imagine it should be, anyone like to point me to the correct way?