Show Posts
1
21.7 Legacy Series / Log corruption in GUI?
« on: September 25, 2021, 11:04:07 am »
At first it seemed I couldn't get anyy logs to show up in the GUI, only older logs would show up. I re-installed, re-used my config from a fresh backup, made sure I was up to date, did a health check. Anything and everything I could think of.
But just now I noticed that my logs are updated, but the GUI initially shows logs which were made during the installation and current logs are only shown much further down even though the dates are newer, or will not show up at all.
I have already checked the logs with clog and everything seems perfectly fine, but all (yes, I've tried most if not all) GUI logging is completely messed up.
Attachment shows a snippet of the audit log, but the results are similar all over.
But just now I noticed that my logs are updated, but the GUI initially shows logs which were made during the installation and current logs are only shown much further down even though the dates are newer, or will not show up at all.
I have already checked the logs with clog and everything seems perfectly fine, but all (yes, I've tried most if not all) GUI logging is completely messed up.
Attachment shows a snippet of the audit log, but the results are similar all over.