1
22.7 Legacy Series / ASIX AX88179A USB3 to Ethernet Adaptor
« on: January 15, 2023, 10:28:27 am »
Hi
Opnsense 22.7.10_2
I want to use the USB to Ethernet Adaptor which has chipset Asix AX88179A. It gets detected by the system but it is continuously flapping. Is there any way to make it work??
Following are the charterstics
Opnsense 22.7.10_2
I want to use the USB to Ethernet Adaptor which has chipset Asix AX88179A. It gets detected by the system but it is continuously flapping. Is there any way to make it work??
Following are the charterstics
Code: [Select]
root@pghome:~ # usbconfig -d ugen0.4mp_device_desc
ugen0.4: <ASIX AX88179A> at usbus0, cfg=0 md=HOST spd=SUPER (5.0Gbps) pwr=ON (46mA)
bLength = 0x0012
bDescriptorType = 0x0001
bcdUSB = 0x0320
bDeviceClass = 0x0000 <Probed by interface class>
bDeviceSubClass = 0x0000
bDeviceProtocol = 0x0000
bMaxPacketSize0 = 0x0009
idVendor = 0x0b95
idProduct = 0x1790
bcdDevice = 0x0200
iManufacturer = 0x0001 <ASIX>
iProduct = 0x0002 <AX88179A>
iSerialNumber = 0x0003 <000000000088A6>
bNumConfigurations = 0x0003
root@pghome:~ # usbconfig -d ugen0.4mp_all_config_desc | grep -i binterface
bInterfaceNumber = 0x0000
bInterfaceClass = 0x00ff <Vendor specific>
bInterfaceSubClass = 0x00ff
bInterfaceProtocol = 0x0000
bInterfaceNumber = 0x0000
bInterfaceClass = 0x0002 <Communication device>
bInterfaceSubClass = 0x000d
bInterfaceProtocol = 0x0000
bInterfaceNumber = 0x0001
bInterfaceClass = 0x000a <CDC-data>
bInterfaceSubClass = 0x0000
bInterfaceProtocol = 0x0001
bInterfaceNumber = 0x0001
bInterfaceClass = 0x000a <CDC-data>
bInterfaceSubClass = 0x0000
bInterfaceProtocol = 0x0001
bInterfaceNumber = 0x0000
bInterfaceClass = 0x0002 <Communication device>
bInterfaceSubClass = 0x0006
bInterfaceProtocol = 0x0000
bInterfaceNumber = 0x0001
bInterfaceClass = 0x000a <CDC-data>
bInterfaceSubClass = 0x0000
bInterfaceProtocol = 0x0000
bInterfaceNumber = 0x0001
bInterfaceClass = 0x000a <CDC-data>
bInterfaceSubClass = 0x0000
bInterfaceProtocol = 0x0000
root@pghome:~ #