Topics

Hello everyone,

My opnsense router has interface (vtnet11) in our local subnet 100.112.241.0/25. That subnet is part of the supernet 10.64.0.0/10 for which gateway (100.112.241.1) is on same interface obviously. We have added a static route to supernet 10.64.0.0/10 in opnsense.

When I ping  VM in local subnet from other opnsense interface, it is routed to supernet 10.64.0.0/10 over GW 100.112.241.1 instead of sending packet directly to subnet to link vtnet11. When I check routing table, I see that static route to GW is displayed before link route and it is probably the reason why the router doesn't send packet directly to VM in subnet.

netstat -rn
100.64.0.0/10      100.112.241.1      UGS     vtnet11
100.112.241.0/25   link#12            U       vtnet11

For better understanding I'm attaching the picture with network diagram.

Is there a possibility to set higher priority on link route, so packets to 100.112.241.0/25 would be always routed to vtnet interface, or is there any other solution how to prefer 100.112.241.0/25 route?

Thanks for all suggestions

Hello,

I'm new to OPNsense. I just installed version OPNsense 20.7.5 (amd64/OpenSSL) on supermicro server with 6 on board nics and 4 nics on expancion pci board. I can see all nics in a system (igb0-igb9)

When I insert cable, link is detected, but when I disconnect the cable, link stays active. When I do ifconfig igb0 down; ifconfig igb0 up status switches to no carrier, but as I need to make lagg on interfaces it is quite an issue.

I found that there was a bug in freebsd https://www.freebsd.org/security/advisories/FreeBSD-EN-20:09.igb.asc, which has been fixed. Was it already implemented into OPNsense?

Thanks.