Show Posts
1
20.1 Legacy Series / wan gui access
« on: March 23, 2020, 09:19:06 pm »
Hello
I am discovering opnsense 20.1, and I have installed it on a vm in my lan, with 2 interfaces, LAN 192.168.1.1, and WAN 192.168.2.xxx - fresh install from the iso.
I am trying to access the management gui via the wan port - In system/settings/administration, I've defined listend to all ports for webgui, etc...
Interfaces WAN : I've unblocked private networks (and bogon networks, just in case !)
I've added a firewall rule, wan, source any, destination wan address, port https
No luck - when I connect to the WAN IP, no gui comes up !
In the logs, I see my rule being triggered, in green, but not gui.
Out of despair, I've done the same config on a fresh pfsense, immediate success !
I've tried adding a nat rule, port forwarding to 192.168.1.1, no luck
Any ideas ? what could be wrong ??
J.
I am discovering opnsense 20.1, and I have installed it on a vm in my lan, with 2 interfaces, LAN 192.168.1.1, and WAN 192.168.2.xxx - fresh install from the iso.
I am trying to access the management gui via the wan port - In system/settings/administration, I've defined listend to all ports for webgui, etc...
Interfaces WAN : I've unblocked private networks (and bogon networks, just in case !)
I've added a firewall rule, wan, source any, destination wan address, port https
No luck - when I connect to the WAN IP, no gui comes up !
In the logs, I see my rule being triggered, in green, but not gui.
Out of despair, I've done the same config on a fresh pfsense, immediate success !
I've tried adding a nat rule, port forwarding to 192.168.1.1, no luck
Any ideas ? what could be wrong ??
J.