1
24.1 Production Series / ConnectX-3 stopped connecting after upgrade to 24.1
« on: March 03, 2024, 09:08:06 pm »
I just updated to 24.1 from 23.7 and everything appears to have gone perfectly fine except for my ConnectX-3 card. After the upgrade completed the port kept flapping. I tried rebooting, doing a complete power down, and unplugging and replugging the attached DAC with no success.
The only thing that appears to have fixed the issue was doing ifconfig down followed by ifconfig up.
Any suggestions for things to check? I didn't have any problems on 23.7 with the card nor the ConnectX-2 that it replaced. Once I get a chance I'm going to try rebooting to see if it comes up correctly or starts flapping again.
The only thing that appears to have fixed the issue was doing ifconfig down followed by ifconfig up.
Any suggestions for things to check? I didn't have any problems on 23.7 with the card nor the ConnectX-2 that it replaced. Once I get a chance I'm going to try rebooting to see if it comes up correctly or starts flapping again.