Show Posts
1
19.1 Legacy Series / [Solved] Can't apply config.xml from 18.7.10_4 - GUI unresponsive
« on: May 16, 2019, 10:51:31 am »
Hi all, need your help or any useful information.
Few days ago I decided to upgrade the distro on my mini-itx pc, made clean-install of 19.1 from USB flashdrive onto SSD. Clean system worked good.
Then I tried to restore settings from previously saved config.xml of 18.7.10_4.
The Web GUI became unresponsive right after config applied and mini pc rebooted. I can't reach or ping or SSH to the mini-pc interface.
But when I conneced monitor straight to the mini pc, all seemed okay, I could login as root, for example.
Same happened, when I tried to upgrade from GUI - clean 19.1 seems fine - tried to restore config - interface unreacheable.
Also when I clean-installed 18.7 and restored config to it - after reboot all is ok, GUI was reacheable.
mini pc config:
Gigabyte GA-H110TN MoBo (dual Intel nics),
4Gb 2133 RAM, 120 Gb SATA SSD,
Intel i350T2 v1 (tried to connect to its igb0).
If I need to do a little more RTFM - please provide a link.
Thanks in advance for your replies.
Few days ago I decided to upgrade the distro on my mini-itx pc, made clean-install of 19.1 from USB flashdrive onto SSD. Clean system worked good.
Then I tried to restore settings from previously saved config.xml of 18.7.10_4.
The Web GUI became unresponsive right after config applied and mini pc rebooted. I can't reach or ping or SSH to the mini-pc interface.
But when I conneced monitor straight to the mini pc, all seemed okay, I could login as root, for example.
Same happened, when I tried to upgrade from GUI - clean 19.1 seems fine - tried to restore config - interface unreacheable.
Also when I clean-installed 18.7 and restored config to it - after reboot all is ok, GUI was reacheable.
mini pc config:
Gigabyte GA-H110TN MoBo (dual Intel nics),
4Gb 2133 RAM, 120 Gb SATA SSD,
Intel i350T2 v1 (tried to connect to its igb0).
If I need to do a little more RTFM - please provide a link.
Thanks in advance for your replies.