"
Hi everyone.
Short version of my problem is:
Are there differences in OpenVPN to WAN routing behaviour between pfSense and OPNsense?
Now here's the long version:
I had a pfSense instance running on a DigitalOcean droplet.
It had an OpenVPN server for road warrior connections that would be routed out to WAN.
Then I found out about OPNsense and redid the whole installation with that, or at least that was the plan.
The said OpenVPN server is also set up to allow road warriors to connect and get routed to WAN.
Connected as road warrior I can ping everything inside the router's private networks, but anything beyond that is either not reachable or doesn't get its replies routed back.
I have tried an accept all rule on the OpenVPN interface as well as an accept all rule for the VPN tunnel IP range, but to no avail.
Any hint would be appreciated.
Short version of my problem is:
Are there differences in OpenVPN to WAN routing behaviour between pfSense and OPNsense?
Now here's the long version:
I had a pfSense instance running on a DigitalOcean droplet.
It had an OpenVPN server for road warrior connections that would be routed out to WAN.
Then I found out about OPNsense and redid the whole installation with that, or at least that was the plan.
The said OpenVPN server is also set up to allow road warriors to connect and get routed to WAN.
Connected as road warrior I can ping everything inside the router's private networks, but anything beyond that is either not reachable or doesn't get its replies routed back.
I have tried an accept all rule on the OpenVPN interface as well as an accept all rule for the VPN tunnel IP range, but to no avail.
Any hint would be appreciated.
