Show Posts
1
General Discussion / Can't access specific device on OPT1 from LAN -- EDITED see first 'reply'
« on: July 29, 2018, 08:31:36 pm »
I'm trying to figure this out. I'm new to OPNsense (in a VM) coming from Shibby Tomato (on my now AP). I set up a rule on OPT1 Interface as follows:
Block - Source:OPT1 Net - Dest:LAN Net
But now they can't communicate at all. My goal to access services on OPT1 but keep LAN safe if OPT1 becomes compromised. I assume this is possible?
Block - Source:OPT1 Net - Dest:LAN Net
But now they can't communicate at all. My goal to access services on OPT1 but keep LAN safe if OPT1 becomes compromised. I assume this is possible?