Show Posts
1
17.7 Legacy Series / Rule enable doesn't block active traffic
« on: November 29, 2017, 02:34:47 am »
Hello All, kind of odd thing I am seeing with my FW:
I have WAN and LAN interfaces configured to block traffic from one specific LAN address to the rest of the LAN network (but still allow to outside WAN). With the rule enabled, pings from this LAN address to the other LAN addresses are blocked - good. However, If I disable the rule, run a -t on the ping, then enable the rule...the pings don't get blocked. I also don't see the actual blocks in the logs. Odd or just something I have set wrong?
I have WAN and LAN interfaces configured to block traffic from one specific LAN address to the rest of the LAN network (but still allow to outside WAN). With the rule enabled, pings from this LAN address to the other LAN addresses are blocked - good. However, If I disable the rule, run a -t on the ping, then enable the rule...the pings don't get blocked. I also don't see the actual blocks in the logs. Odd or just something I have set wrong?