Show Posts
1
General Discussion / Captive Portal two LAN subnets, how to capture just one?
« on: August 04, 2017, 09:08:09 pm »
Greetings,
I am somewhat of a newbie with OPNSense and I am running the below:
OPNsense 17.7-amd64
FreeBSD 11.0-RELEASE-p11
OpenSSL 1.0.2l 25 May 2017
with two network cards so WAN and LAN. I have two subnets that need to to be available for the LAN of 172.16.0.1/16 and 172.17.0.1/24. I looked for a way to create a virtual adapter to isolate the 172.17.0.1/24, but only found Firewall/Virtual IP's to add the second subnet of 172.17.0.1/24 to LAN. I have created the captive portal with interface LAN and on allowed addresses I put 172.16.0.1/16. So I would think that the captive portal should only capture (splashed for authentication) 172.17.0.1/24, however it is still capturing the 172.16.0.1/16 address subnet.
Thanks in advance for any ideas.
I am somewhat of a newbie with OPNSense and I am running the below:
OPNsense 17.7-amd64
FreeBSD 11.0-RELEASE-p11
OpenSSL 1.0.2l 25 May 2017
with two network cards so WAN and LAN. I have two subnets that need to to be available for the LAN of 172.16.0.1/16 and 172.17.0.1/24. I looked for a way to create a virtual adapter to isolate the 172.17.0.1/24, but only found Firewall/Virtual IP's to add the second subnet of 172.17.0.1/24 to LAN. I have created the captive portal with interface LAN and on allowed addresses I put 172.16.0.1/16. So I would think that the captive portal should only capture (splashed for authentication) 172.17.0.1/24, however it is still capturing the 172.16.0.1/16 address subnet.
Thanks in advance for any ideas.