Topics

1

17.1 Legacy Series / Two openVPN servers?

« on: May 03, 2017, 02:31:15 am »

I have my Google Compute Engine micro-f1 VM running OPNsense 14!  I have another OPNsense installation running in my office (behind a campus router).

The goal is to VPN between my office and the GCE, then VPN from the GCE to road warriors.  I have custom hardware in my office I need to allow road warriors to access.

If I follow the "Setup SSL VPN site to site tunnel" then "Setup SSL VPN Road Warrior"  I end up with two openVPN servers running on the GCE system on two ports.

Is that the smart way to reach my goal?

2

17.1 Legacy Series / Google Compute Engine VM Install

« on: May 01, 2017, 03:36:08 am »

I feel like I am getting pretty close.  It has been a struggle.  I loaded OPNsense 17.1 into VirtualBox to generate an image.  I have the image created and transferred to gcp.  GCP recognizes the image an boots the VM.  I have the serial terminal running to monitor the boot.  Unfortunately I don't get a menu at the end of booting.  Also SSH fails.

I didn't assign any interfaces in VirtualBox because I knew they would change when it booted on GCP.

My goal is to get it running on the low cost micro instance.

Can you provide any clues from this log?  I'll share the image if I can get it working.

                 /  __  |/ ___ |/ __  |                       
                 | |  | | |__/ | |  | |___  ___ _ __  ___  ___
                 | |  | |  ___/| |  | / __|/ _ \ '_ \/ __|/ _ \
                 | |__| | |    | |  | \__ \  __/ | | \__ \  __/
                 |_____/|_|    |_| /__|___/\___|_| |_|___/\___|
--Log cleared because it wasn't important.