1
24.1 Production Series / Peer generator: WireGuard Instance not saved / QR-Code Config not working
« on: April 04, 2024, 11:30:06 pm »
Hello all,
I'm not sure if this is a specific issue from my environment, but I updated to 24.1.5 today and wanted to try the Wireguard Peer generator.
I ran into two issues:
1. The "Instance" selected in the Peer generator is not saved after clicking on the "Store and generate next" Button.
If you switch back to the "Peers", the Instance of the newly created Peer is empty.
2. I scanned the QR-Code on my Android Phone using "Wireguard for Android 1.0.20231018". Importing the config is working, but I can not establish the connection. Error message on the Phone is "Fehler beim Starten des Tunnels: at least on address must be specified"
I have to edit the configuration on the Phone and enter an IP-Address at the "Interface -> Adressen" Field that is in the Instance's IP range to make it work.
Is anybody else having these issues?
Best regards,
Patrick
I'm not sure if this is a specific issue from my environment, but I updated to 24.1.5 today and wanted to try the Wireguard Peer generator.
I ran into two issues:
1. The "Instance" selected in the Peer generator is not saved after clicking on the "Store and generate next" Button.
If you switch back to the "Peers", the Instance of the newly created Peer is empty.
2. I scanned the QR-Code on my Android Phone using "Wireguard for Android 1.0.20231018". Importing the config is working, but I can not establish the connection. Error message on the Phone is "Fehler beim Starten des Tunnels: at least on address must be specified"
I have to edit the configuration on the Phone and enter an IP-Address at the "Interface -> Adressen" Field that is in the Instance's IP range to make it work.
Is anybody else having these issues?
Best regards,
Patrick