Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - nivok

#1
19.7 Legacy Series / Dynamic state reset
November 10, 2019, 02:54:44 PM
Hello guys,
I'm facing an issue that I can't seem to solve correctly and I'd love to get a tip of best practices:

I've 2 wans, one of them is a PPPoe and has it's target gateway changing from time to times. As I've a SIP PBX in the background, I've set the "Dynamic state reset" flat on the advance param. Unfortunatelly, this flag does not seem to be compatiple with the OpenVPN client that I use, as once the VPN client receives via DHCP an new ip, the states are reset and the connection is dropped.

Can I somehow enable the "Dynamic state reset" flag only for one interface? Or is there anoter way to achieve this ?
Thanks a lot in advance and best regards,
Nick
#2
Hello,
I'm new to opnsense and I'd like an advice if possible.
I've by my ISP a block of 8 public IPs (among which 5 are usable).
Currently, they'are assigned directly on the router with Port Forwarding to different servers.
I would like to have opnsense in between and manage everything from there.
According to the manual of the router, I can put in in PPPoE mode and thus use it as a bridge. I've tried to set that up in opnsense and it works of (I see PPPoE being "online")
What I can't seem to figure out is how to configure my IPs in opnsense so I can do Port Forward to my servers.
Do I need virtual IPs ? I've a /29 block (Let's say i.e. 172.16.75.96/29 (97 being the router, 98-102 usable and 103 the broadcast)
Can someone please help me out ?
Thanks a million in advance,
Nick