Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Topics - vocatus

#1
I installed v18.1.6 amd 64 nano to an SG-2440.

The problem is that it hangs at "booting..." after a lot of text scrolls by (once it gets past the menu)

What should I do?
#2
I have a Netgate SG-2440 running latest OPNSense 17.1 series.

Cannot for the life of me get wireless working. Radios are on, SSID assigned, etc but the network simply never shows up to any devices.

Is wireless broke in OPNSense (pfsense wireless support is no better..) or am I missing something obvious?
#3
Hi there,

Running v17.1.4 nano x64.

The following port forwarding rules are configured (see attached images). Created various NAT port forwards and associated firewall rules.

None of the forwards work. Especially tested were the RDP/RDC rules.

Information:

- Hardware is Netgate SG-2440

- ISP is not doing carrier-grade NAT; router has a public IP address

- Router responds to ICMP echo requests on the WAN interface

- This configuration worked 100% on pfsense 2.3.3-RELEASE AMD64

Can I provide any additional information? After doing some googling it appears that port forwarding is likely actually broken in OPNSense v16+
#4
17.1 Legacy Series / Boot hang on Netgate SG-2440 (nano)
February 20, 2017, 07:16:58 PM
Hi there, new to OPNsense and coming from a longtime pfSense background. Trying to install latest version (17.1) on my Netgate SG-2440 (Intel Atom based).

Booting from USB, OPNsense gets to the initial splash screen (with options), but no matter what options I use (safe mode on/off, ACPI on/off, etc) it hangs on booting at the ng_tcpmss.ko file.

I tried using the Serial image instead of Nano, and it also hung, this time at /boot/defaults/loader.conf

Screenshots attached.

Any help appreciated!