Show Posts
1
General Discussion / WebGUI accessible on WAN interface
« on: December 03, 2016, 12:08:26 pm »
My OPNSense FW is behind a cable modem. I'd like to enable VPN to access my home network and therefore turned the modem into "bridge mode" (my provider is Kabel Deutschland, btw). After doing that I can access the WebGUI of my OPNSense firewall from outside. Why is that? My understanding is, that OPNSense doesn't allow connections to the WebGUI on the WAN interface.
I've tried to find a setting for disabling access to the WebGUI, but didn't find any. Do I need to set up firewall rules for blocking? I the anti-lockout rule in the NAT settings the culprit for that behavior?
I've tried to find a setting for disabling access to the WebGUI, but didn't find any. Do I need to set up firewall rules for blocking? I the anti-lockout rule in the NAT settings the culprit for that behavior?