1
General Discussion / [SOLVED] Multiple interfaces with 802.1Q
« on: January 07, 2016, 09:12:58 pm »
Hi!
I have an OPNsense virtualized over Xenserver. The physical interface is connected to the switch over a trunk port that permits all the VLANs.
I need multiple LAN (11) interfaces and two Wan interfaces on OPNsense. I'm able to add and map all the interfaces on the guest through the xen CLI interface. OPNsense recognizes all the interfaces, but I'm only able to add/enable 7 interfaces. It is possible to add more then 7 logical interfaces, each attached to one VLAN? How can I achieve that?
Thank you in advance!
Regards,
Augusto
I have an OPNsense virtualized over Xenserver. The physical interface is connected to the switch over a trunk port that permits all the VLANs.
I need multiple LAN (11) interfaces and two Wan interfaces on OPNsense. I'm able to add and map all the interfaces on the guest through the xen CLI interface. OPNsense recognizes all the interfaces, but I'm only able to add/enable 7 interfaces. It is possible to add more then 7 logical interfaces, each attached to one VLAN? How can I achieve that?
Thank you in advance!
Regards,
Augusto