Show Posts
1
General Discussion / Switch between LAN and DMZ blocks
« on: November 02, 2015, 09:13:03 am »
Hello,
I have an issue with the router FW-7568A on OPNsense 15.7.17-amd64 / FreeBSD 10.1-RELEASE-p19 / OpenSSL 1.0.2d 9 Jul 2015.
We configured three out of height interfaces :
1) em0 = LAN
2) em1 = WAN
3) em2 = DMZ
When we connect our workstation on DMZ interface (em2), we have an internet connection, the problem is when we reconnect our workstation on LAN interface (em0) we get an IP address of LAN network, but we don't have access to internet.
To recover an internet connection, we have to apply a change on a rule (even if it is disable).
The rules configured on the router are the following :
- LAN : Defaults rules (after a « reset to factory defaults »)
- WAN : Defaults rules (after a « reset to factory defaults »)
- DMZ : « DMZ allow to any rules »
Best regards,
Thank you.
I have an issue with the router FW-7568A on OPNsense 15.7.17-amd64 / FreeBSD 10.1-RELEASE-p19 / OpenSSL 1.0.2d 9 Jul 2015.
We configured three out of height interfaces :
1) em0 = LAN
2) em1 = WAN
3) em2 = DMZ
When we connect our workstation on DMZ interface (em2), we have an internet connection, the problem is when we reconnect our workstation on LAN interface (em0) we get an IP address of LAN network, but we don't have access to internet.
To recover an internet connection, we have to apply a change on a rule (even if it is disable).
The rules configured on the router are the following :
- LAN : Defaults rules (after a « reset to factory defaults »)
- WAN : Defaults rules (after a « reset to factory defaults »)
- DMZ : « DMZ allow to any rules »
Best regards,
Thank you.