Topics

1

15.7 Legacy Series / [SOLVED] Connect with WINSCP

« on: November 08, 2015, 10:01:16 pm »

Hi Folks,

did anyone try to connect to opnsense through winscp. i'm getting error message (attached)

and yes SSH is enabled, in short i can access with putty which ensures that it's not a firewall problem.

thanks

OK I FOUND THE SOLUTION BY MYSELF. IT'S JUST TO USE SFTP PROTOCOL NOT SCP. SCP WORKS ONLY WITH PUTTY TO GET ACCESS TO THE TERMINAL.

2

15.7 Legacy Series / Traffic Shaper in Bridged mode

« on: November 06, 2015, 09:04:22 am »

Hi everybody,

my best wishes to OPNsense. the new promising firewall.

I've been testing it for a week now and I've struggled a little with creating a bridge between WAN and LAN and access the web management from bridge interface but I did it finally.

NOW, I've tried to apply this guide https://wiki.opnsense.org/index.php/Traffic_shaper to my setup which works for a few seconds and the speed drops down to 80Kb/S  which should be 512Kb/S.

Please any Ideas, workaround , fix or alternative package that can do a bandwidth limit per user in bridged mode.

thanks to you all.