Messages

1

Virtual private networks / Re: Wireguard - No Handshake, No Incomming Traffic, No Client Errors

« on: February 24, 2024, 03:20:30 pm »

Attached the Issue with the repro.

I have now deleted everything and reinstalled Warrior Setup. It still does not work.
I don't see any traffic on the selected port in the firewall livelog either. Despite the Exposed Host being set up on the Fritzbox.

2

Virtual private networks / Re: Wireguard - No Handshake, No Incomming Traffic, No Client Errors

« on: February 09, 2024, 08:15:59 pm »

At the moment the repository doesn't seem to be working. So I can't reinstall it right now.

I followed the instructions in the documentary and then used YouTube to help.

3

Virtual private networks / Re: Wireguard - No Handshake, No Incomming Traffic, No Client Errors

« on: January 30, 2024, 09:27:49 pm »

Yes this instructions were my first try.

4

Virtual private networks / Re: Wireguard - No Handshake, No Incomming Traffic, No Client Errors

« on: January 30, 2024, 09:09:27 pm »

I have set up a packet capture for the wg1 interface. Afterward, I activated the connection on the client. However, the capture doesn't show anything.

5

Virtual private networks / Wireguard - No Handshake, No Incomming Traffic, No Client Errors

« on: January 30, 2024, 08:34:44 pm »

Hello,

I've been trying, searching, and reading instructions for several days now, but my Wireguard doesn't establish a handshake. In the firewall live log, I don't see any incoming traffic on the configured port. I've created a WAN incoming rule, designated the firewall as an exposed host on the Fritzbox in front of it, and defined the ports again as a separate forwarding.

The log on the client also doesn't report any errors. Does anyone have an idea where else I could look for the error?

 :'( :'( :'(

Thank you.