1
General Discussion / Re: dhcpv6 question
« on: April 16, 2024, 06:35:23 am »
ps wuax | grep dhcp6c will tell you which config file it uses, usually /var/etc/dhcp6c.conf.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
port destination: ! LAN net"!" means NOT(invert), so turn on that "Destination/Invert" checkbox.
mount -u -o rw /
opnsense-shell password
2024-04-09T17:46:37-05:00 Notice kernel <6>re0: link state changed to UP
2024-04-09T17:46:33-05:00 Notice kernel <6>re0: link state changed to DOWN
Is this behavior correct? I would think "WAN Address" would only match the address specifically assigned to the interface, rather than any of the virtual IPs..In pf "<Interface name> Address" means all addresses of the interface, VIPs included.
Would you happen to know if I still need to set a cron job for OPNsense to update its time via chrony, or if the plugin takes care of that now? I've run into the same situation as this post hereNot needed, chronyd will manage local clock and provide service to network clients as long as it is running.