Messages

1

Hardware and Performance / Re: How to install OPNsense on a Netgate SG-5100 - USB console issues

« on: February 16, 2023, 09:37:51 pm »

Ok

It looks quite simple then.

I'll read some dmesg logs to dig for firmware problems, try some confs and read some logs before installing.

I think i'll `dd` the whole drive before installing anything.

Will give some input if i succeed.

 Thanks for your help.

2

Hardware and Performance / Re: How to install OPNsense on a Netgate SG-5100 - USB console issues

« on: February 16, 2023, 06:29:22 pm »

Hi @pmhausen

Actually i'm a linux guy not really comfortable with bsd. I'm learning .

I didn't try anything for now. I need to figure out which bootloader is and how to boot from media.
 i'll try with this :

https://docs.opnsense.org/manual/install.html

I'll try to add some other m2 disk :

https://docs.netgate.com/pfsense/en/latest/solutions/sg-5100/m-2-sata-installation.html

As i'm not comfortable i don't want to brick the appliance.

Any advice on needed precautions would be very appreciated.

3

Hardware and Performance / Re: How to install OPNsense on a Netgate SG-5100 - USB console issues

« on: February 15, 2023, 11:00:28 pm »

HI friends.

Is it possible to necrobump this thread as the initial question is still unanswered:

How to install opnsense on this appliance ?

I mean technically is there any guide or howto ? 

Thank you good fellows and long live to opnsense !

4

Hardware and Performance / Re: Driver HP NC523SFP DUAL PORT 10Gb SERVER ADAPTER

« on: September 10, 2022, 06:28:58 pm »

Hi fellows.

I'm new to opnsense and more generally to the bsd universe.
It's very different from the linux world and i feel like i have a long road in front of me.

So i try to have thic NIC working on a home router to do some bsd lab.

I got issue with OPNsense-22.7

I installed it on a box.

I tried to load the module with :

Code: [Select]

kldload if_qlxgb
as testo_cz suggested

It seems the module can't load properly  :

my dmesg :

Code: [Select]

ql0: <Qlogic ISP 80xx PCI CNA Adapter-Ethernet Function v1.1.36> mem 0xf7a00000-0xf7bfffff,0xf7c90000-0xf7c9ffff at device 0.0 on pci1
ql0: qla_init_from_flash: func[0] Q8_PEG_HALT_STATUS1[0x00000000] STATUS2[0x00000000] HEARTBEAT[0x00000000] RCVPEG_STATE[0xffffffff] CMDPEG_STATE[0x00000000]
ql0: qla_pci_attach: qla_init_hw failed
device_attach: ql0 attach returned 6
I need a little hint here.

Found posts on other forums telling to compile module from older bsd version .
Can someone please help me to confirm this ?


Than you very much.

Regards.