1
22.1 Legacy Series / Re: IPsec VPN GUI configuration in 22.1 phase 2 totally different
« on: March 08, 2022, 10:31:51 pm »
I just tested out 22.1.2_1 and it looks like it's fixed. Thanks!
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
22.1 Legacy Series / IPsec VPN GUI configuration in 22.1 phase 2 totally different
« on: March 03, 2022, 03:46:08 am »
I apologize if this is a dumb question, but I've upgraded to 22.1 from various previous versions and see that the IPsec VPN Tunnel Settings config in the GUI is totally different. Instead of Phase 2 configs being attached to Phase 1 configs, I now see it's a totally separate section in Tunnel Settings. When configuring Phase 2, I don't see the option for remote network either. Am I totally missing something here?
3
21.1 Legacy Series / Re: Proper WAN download speed but very slow WAN upload speed
« on: July 06, 2021, 11:58:42 pm »
Thanks for helping troubleshoot! Actually, I fixed (well, more specifically, worked around) the upload slowness issue. The ultimate issue stemmed around the SFP+ ports on the DEC840 - using them at all seems to cause all-around issues: slow speeds in 1 direction, inability to use 1 Gbit SFP modules, etc. Trying all the combinations of ports indicated the SFP+ ports were the culprit. Totally disabling them cleared everything up, but now we're limited to 1 Gbit/s even when routing between internal nets. This is an acceptable workaround for now. The 1000base-T ports seem to work properly when solely using them.
4
21.1 Legacy Series / Proper WAN download speed but very slow WAN upload speed
« on: July 05, 2021, 09:35:51 pm »
Hello everyone! I've got a DEC840 running OPNsense 21.4.1-amd64 that's showing strange behavior on a 1 Gbit/s down/1 Gbit/s up internet connection. The WAN port is connected via a regular 1000base-T port to the upstream ISP, and I've confirmed that I get gigabit speeds in both down/up when directly plugged into my computer. However, using the OPNsense device, I get the expected down speed but very slow up speed, ~1-3 Mbit/s. This happens with more or less the default starting configuration with 1 WAN and 1 LAN port. I've tried things like trying the other ports and explicitly setting the connection to 1000base-T full duplex instead of the default autonegotiate and no luck. Any ideas? Thanks in advance.
Pages: [1]